The Panoramic WiFi Gateway is a popular device used by many to access high-speed internet and create home networks. One of the advanced features it offers is Bridge Mode, which allows users to bypass the router functionality of the gateway and use it solely as a modem. Enabling Bridge Mode can be useful in situations where you want to use your own router or have specific networking requirements. In this article, we will guide you through the process of enabling Bridge Mode on the Panoramic WiFi Gateway.
Before we begin, it’s essential to note that not all internet service providers (ISPs) allow customers to enable Bridge Mode on their gateways. Some ISPs may restrict this feature, so it’s crucial to check with your provider beforehand. Assuming your ISP permits it, let’s proceed with the steps to enable Bridge Mode:
1. Access the Panoramic WiFi Gateway Settings
To access the settings of your Panoramic WiFi Gateway, you need to connect to it using a computer or mobile device. Connect to the gateway’s network either via Ethernet cable or wirelessly using the default network name (SSID) and password mentioned on the gateway’s label.
2. Open the Gateway Admin Panel
Open a web browser on your device and enter the default gateway IP address in the address bar. The default IP address for the Panoramic WiFi Gateway is typically “10.0.0.1” or “192.168.0.1”. Press Enter to proceed.
3. Enter Login Credentials
On the gateway admin panel login page, enter the default username and password provided with your gateway. If you have changed the login credentials before, use the updated ones. If you don’t know the default username and password, refer to the user manual or contact your ISP for assistance.
4. Navigate to the Bridge Mode Settings
Once you have successfully logged in to the admin panel, look for the settings related to Bridge Mode or Router Mode. The location of these settings may vary depending on the gateway’s firmware and software version. In some cases, you might find the option under “Advanced Settings” or “Gateway Mode.”
5. Enable Bridge Mode
When you find the Bridge Mode settings, select the option to enable it. You may be asked to confirm your choice or make additional configurations. Read any on-screen instructions or prompts carefully to ensure the correct setup.
6. Save and Apply Changes
After enabling Bridge Mode, remember to save and apply the changes you made in the settings. This action ensures that the Panoramic WiFi Gateway reboots with the new configuration.
7. Connect Your Own Router
Once the gateway reboots, you can connect your own router to the gateway using an Ethernet cable. This setup allows your router to handle the network routing functions, while the Panoramic WiFi Gateway acts solely as a modem.
8. Configure Your Router
Now that your own router is connected, configure it according to your preferences. Set up your WiFi network name (SSID), password, security settings, and any other desired configurations. You can refer to the user manual of your router or contact the manufacturer for detailed instructions on the configuration process.
That’s it! You have successfully enabled Bridge Mode on the Panoramic WiFi Gateway and connected your own router to it. Remember that by enabling Bridge Mode, you disable the routing capabilities of the gateway, and all network functions are handled by your router. If you encounter any issues during the process or experience connectivity problems, it’s recommended to reach out to your ISP for assistance.
Disclaimer: The process described in this article is based on general instructions for enabling Bridge Mode on the Panoramic WiFi Gateway. However, specific steps and options may vary depending on your ISP and the firmware version of your gateway. Always refer to the official documentation provided by your ISP or contact their customer support for accurate instructions.